Work sequence
WARNING: This page is about a different variant/trim than selected.
- With engine at idle connect Scan Tool (ST) V.A.G 1551 / V.A.G 1552 and select Engine Control Module (ECM) with "Address word" 01. → Scan Tool V.A.G 1551 , connecting , V.A.G 1551 Scan Tool, connecting.
Indicated on display:
| Rapid data transfer HELP Select function XX |
- Press buttons - 0 - and - 8 - for "Read measuring value block" and confirm with - Q - button.
Indicated on display:
| Read measuring value block HELP Input display group number XXX |
- Select display group number.
NOTE:
- Display group number - 0 - is an example, to illustrate sequence.
- Press buttons - 0 - , - 0 - and - 0 - for "Display group number -0-" and confirm with - Q - button.
Indicated on display:
| Read measuring value block 0 -> 1 2 3 4 5 6 7 8 9 10 |
(1...10 = Display zones)
NOTE:
- To change to another display group proceed as follows:
| Display group | V.A.G 1551 | V.A.G 1552 |
| Higher | Press button 3 | Press ↑ button |
| Lower | Press button 1 | Press ↓ button |
| Skip | Press button C | Press button C |
- If specifications in all display zones are obtained, press → button.
Indicated on display:
| Rapid data transfer HELP Select function XX |
- Press buttons - 0 - and - 6 - for "End output" and confirm with - Q - button.
- Switch off ignition.