Activating Wastegate Bypass Regulator valve N75
WARNING: This page is about a different variant/trim than selected.
- Press → button.
Indicated on display:
| Output Diagnostic Test Mode -> Wastegate Bypass Regulator Valve N75 |
The solenoid valve must operate and the rod for the charge pressure control pressure unit on the turbocharger must move back and forth (at least 3 - 4 times, as long as there is vacuum in the vacuum reservoir).
If solenoid valve does not operate:
- Check charge pressure control solenoid valve N75 : → 21 - TURBOCHARGER, G-CHARGER