Work sequence

WARNING: This page is about a different variant/trim than selected.

Connect Vehicle Diagnostic, Testing and Information System VAS5051 using diagnostic cable VAS5051/1 or diagnostic cable VAS5051/3B as follows:

Fig 1: VAS 5051 Connected To Data Link Connector

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Push plug of diagnostic cable onto diagnostic connection.
Depending upon desired function: Switch ignition on or Start engine Selectable functions (modes) under address word 33, CARB / OBD II .

NOTE:

In the functions 04 - Basic setting/08 - Read data block, the display zones will be listed from top to bottom.
If the display does not indicate as described in the work sequence: VAS5051 Vehicle Diagnostic, Testing and Information System operating instructions

Fig 2: Selecting Operating Mode On VAS 5051

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Indicated on display: