Display group 71 -Exhaust reduction- Leak diagnostic system
WARNING: This page is about a different variant/trim than selected.
Readiness code
| Display group 71 -Exhaust reduction- Leak diagnostic system | ||||||
|
||||||
|
||||||
|
||||||
| Read Measuring Value Block 71 | → | Indicated on display | ||||
| Text | Text | Text | Text | |||
| 1 | 2 | 3 | 4 | Display zones | Specification | Evaluation |
| Result of diagnostic (Test ON/ OFF, Syst. OK / n.OK) | Syst. OK | --- | ||||
| Diagnostic status (Syst.Test/End.Test) | End of Test | --- | ||||
| DTC message (small leak/large leak) | --- | --- | ||||
| Reed-contact condition (Reed closed/Reed open) | Reed open | --- | ||||
NOTE:
- Coolant temperature should be below 80° C during the test, check → Measuring value blocks, evaluating display groups 0 to 9 (Basic functions) .