Display group 60 -RPM regulation- adaptation EPC system 1)
WARNING: This page is about a different variant/trim than selected.
Readiness code
| Display group 60 -RPM regulation- adaptation EPC system 1) | ||||||
|
||||||
|
||||||
| Read Measuring Value Block 60 | → | ← Indicated on display: | ||||
| xx % | xx % | x | Text | |||
| 1 | 2 | 3 | 4 | ← Display fields | Specified value | Evaluation |
| Adaptation condition (ADP in progress, ADP OK or ADP error) | ADP OK | --- | ||||
| Adaptation step counter | 0 - 8 | --- | ||||
| Throttle valve angle (angle sensor -2- for throttle drive -G188-) | 60 - 94% | --- | ||||
| Throttle valve angle (angle sensor -1- for throttle drive -G187-) | 8 - 60% | --- | ||||
1) Adapt Engine Control Module (ECM) to throttle valve control module. Refer to Throttle valve control module, adapting to engine control module .
Notes for display group 60:
- Adaptation of the throttle valve control module is performed with ignition switched on.
- When display group 60 is selected under function 04 "basic setting", the Engine Control Module (ECM) is adapted to the throttle valve control module. This adaptation must always be performed if a different throttle valve control module (or completely new engine) or a different Engine Control Module (ECM) is installed.
- During adaptation, the counter in display field 3 counts up to 8