Part I
WARNING: This page is about a different variant/trim than selected.
1 - Ribbed belt
- Mark direction of engine rotation before removing
- Check for wear
- Do not kink
- Removing and installing. Refer to Ribbed belt, removing and installing
- Vehicles with air conditioning system with additional idler roller, removing and installing. Refer to Idler roller, removing and installing
2 - 10 Nm plus an additional 1 / 4 turn (90 ° )
- Always replace
- Torque angle can be measured with Hazet 6690 torque angle meter, or equivalent
3 - Belt pulley/vibration damper
- Can only be installed in one position; holes are offset
4 - 25 Nm
5 - Tensioning element
6 - Generator
7 - Assembly bracket
- For injection pump, generator, and power steering pump
- For vehicles without air conditioning system
- Assembly bracket for vehicles with air conditioning system, removing and installing: Refer to 87 - AIR CONDITIONING
8 - 45 Nm
9 - Banjo bolt, 30 Nm
10 - Oil seal
- Always replace
11 - Pressure line
12 - Pump
- For power steering
- Removing and installing: Refer to 48 STEERING
13 - Pulley
- For power steering pump