Test requirements
WARNING: This page is about a different variant/trim than selected.
- There must not be any DTCs stored in DTC memory, see DIAGNOSTIC MODE 3: CHECK DTC MEMORY .
- Coolant temperature must be 80 to 110 °C, see DIAGNOSTIC MODE 1: CHECK MEASURED VALUES ; PID 5, Coolant temperature.
- Intake air temperature must not be above the maximum of 60 °C, see DIAGNOSTIC MODE 1: CHECK MEASURED VALUES ; PID 15, Intake air temperature.
- Throttle valve angle 12.0 to 16.0 %, see DIAGNOSTIC MODE 1: CHECK MEASURED VALUES ; PID 17: Throttle valve position (absolute)