Multi-Function Transmission Range (TR) Switch F125, Installing And Adjusting
WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2006 Volkswagen Golf, 2006 Volkswagen GTI, 2005 Volkswagen Jetta, 2005 Volkswagen Golf, and 2005 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.
- Place multifunction switch F125 on selector shaft.
Installation position:
Fig 2: Groove In Selector Shaft Must Line Up With Mark On Multi-Function Transmission Range (TR) Switch F125
Groove - 1 - in selector shaft must line up with mark - 2 - on Multi-Function Transmission Range (TR) Switch F125.
Fig 3: Tighten Securing Bolts For Multi-Function Transmission Range (TR) Switch F125 Until Finger-Tight
- Tighten securing bolts - arrows - for Multi-Function Transmission Range (TR) Switch F125 until finger-tight.
- Place setting gauge on selector shaft and secure it.
- Move selector shaft lever on transmission to position "N".
- Turn switch so that dowel hole in switch housing - 1 - lines up with hole in setting gauge.
- Push in dowel pin - 2 - of setting gauge.
- Tighten securing bolts - arrows - for Multi-Function Transmission Range (TR) Switch F125.
- Connect connector - 2 - wire for multifunction switch.
- Push lever - 1 - onto selector shaft.
- Tighten nut - arrow -.
- Install selector lever cable, refer to Selector lever cable, removing and installing .
- Install battery and battery holder. Refer to 27 BATTERY, STARTER, GENERATOR, CRUISE CONTROL .
- Connect Ground (GND) strap to battery.
- Code radio, refer to 91 RADIO, TELEPHONE, NAVIGATION, TRIP COMPUTER .