Assembly Continuation

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2006 Volkswagen Golf, 2006 Volkswagen GTI, 2005 Volkswagen Jetta, 2005 Volkswagen Golf, and 2005 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.

Remove thrust washer again from "K2" and attach in cover with petroleum jelly (e.g. Vaseline).

Fig 1: Installing Spring

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Install spring - 2 -.

The spring installs in only one position.

Install Transmission Input Speed (RPM) Sensor G182 - 1 -.

Next, ATF lines must be installed. Do not cant lines during installation and push both ends evenly into transmission housing to stop.

Fig 2: First Install ATF Lines And Then Install ATF Line With Line Clips

Courtesy of VOLKSWAGEN UNITED STATES, INC.

First install ATF lines - 1 - and - 2 -.
Then install ATF line - 3 - with line clips - A -.

Fig 3: Inserting Seal -B- Into Transmission Housing

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Insert seal - B - into transmission housing.