Adjustment procedure

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2006 Volkswagen Golf, 2006 Volkswagen GTI, 2005 Volkswagen Jetta, 2005 Volkswagen Golf, and 2005 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Locking Lever And Locking Cable Eye

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Loosen bolt on support bracket.
Push on Adjustment Pin For Shift lock 3 3352 A between locking lever - 1 - and locking cable eye - 2 -.
To adjust play, pull support bracket to stop in direction of - arrow -.
In this position, it must be possible to remove and insert Adjustment Pin For Shift lock 3 3352 A easily.

Fig 2: Tightening Bolt On Support Bracket

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Tighten bolt on support bracket to 10 Nm.
Remove adjustment gauge.
Check operation of ignition key removal lock. Refer to Ignition key withdrawal lock, checking operation .