Diagnostic Trouble Code (DTC) memory, erasing
WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2006 Volkswagen Golf, 2006 Volkswagen GTI, 2005 Volkswagen Jetta, 2005 Volkswagen Golf, and 2005 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.
Requirement:
- DTC memory checked. Refer to Diagnostic Trouble Code (DTC) memory, checking .
- Vehicle stationary.
- Engine speed not above 960 rpm.
After DTC memory has been checked:
Indicated on display
| Rapid data transfer HELP Select function XX |
- Press keys 0 and 5 to select function "Erase DTC memory".
Indicated on display
| Rapid data transfer Q 05 - Erase DTC memory |
- Confirm entry with key Q.
Indicated on display
| Warning! DTC memory was not checked. |
NOTE:
- If the ignition was switched off e.g. between checking the DTC memory and erasing the DTC memory, the DTC memory is then not erased.
- Adhere strictly to the sequence of operations, i.e. first of all check the DTC memory.
Indicated on display
| DTC memory is not erased |
If one or more DTCs are present.
- Check DTC memory. Refer to Diagnostic Trouble Code (DTC) memory, checking .
Indicated on display
| Rapid data transfer → DTC memory is erased! |
The DTC memory will be erased approx. 5 seconds after the display appears.
The DTC memory is now erased.
NOTE:
Wait about 1 minute before again checking the DTC memory.
Indicated on display
| System cannot be checked! |
Print out with printer switched on
| 1 DTC recognized ! 00811 3333 System cannot be checked |
Transmission control module (TCM) -J217- was not given sufficient time to recognize DTCs.
- Wait about 1 minute before again checking DTC memory.
- After checking and erasing DTC memory, test drive vehicle and again check DTC memory.
When the DTC memory is checked, the following display should appear:
"No DTC recognized!"