LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2001 >> Jetta GL, 2.0 B >> Repair and Diagnosis >> External Pages >> Different car >> Section 78 (1.9L - Fuel Injection Glow Plug, Engine Code ALH, From My 2002 (A4 Platform)) >> 01 On Board Diagnostic (OBD) >> Function 03: Output Diagnostic Test Mode (DTM) >> Performing Output Diagnostic Test Mode >> Prerequisites (with air conditioning)

Prerequisites (with air conditioning)

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2006 Volkswagen Golf, 2005 Volkswagen Jetta, 2005 Volkswagen Golf, 2004 Volkswagen Jetta, and 2004 Volkswagen Golf. However, it is still accessible from the selected car via links, so may be relevant.

The Output diagnostic test mode activates the following components in the following sequence:

1. Cold Start Injector N108

2. EGR Vacuum Regulator Solenoid Valve N18

3. Air Conditioning compressor interrupt

4. Fuel Cut-off Valve N109

5. Wastegate Bypass Regulator Valve N75 for boost control

6. Glow Plug Relay J52

7. Glow Plug Indicator Lamp K29

8. Relay J359 preheat coolant, low heat output (man. trans. only)

9. Relay J360 preheat coolant, high heat output (man. trans. only)

10. Malfunction Indicator Lamp (MIL) K82 , Exhaust Warning Lamp K83 - (MIL is shown in the 1551 display, however; K83 Exhaust Warning Lamp is the actual component being tested)

NOTE:
  • Activation of individual control elements is limited to 30 seconds. but can be stopped at any time by pressing → button.
  • Ignition must be switched off before repeating Output Diagnostic Test Mode.