LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2001 >> Jetta GL, 2.0 B >> Repair and Diagnosis >> External Pages >> Different car >> Section 77 (2.8L - Engine Mechanical, Engine Code: BDF) >> 19 - Engine - Cooling System >> Cooling system components, servicing >> Cooling system, draining and filling >> Filling

Cooling system, draining and filling: Filling

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Volkswagen GTI, 2004 Volkswagen Jetta, 2004 Volkswagen GTI, 2003 Volkswagen Jetta, and 2003 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • Only use coolant additive G 12 in accordance with TL VW 774 D. Identification color: red
  • Under no circumstances must G 12 be mixed with other coolant additives!
  • If the fluid in expansion tank is brown, G 12 has been mixed with another coolant. In this case the coolant must be changed.
  • G 12 and coolant additives marked In accordance with TL VW 774 D prevent frost and corrosion damage, scaling and also raise the boiling point of coolant. For this reason the system must be filled all year round with frost and corrosion protection additives.
  • Because of its high boiling point, the coolant improves engine reliability under heavy loads, particularly in countries with tropical climates.
  • Protection against frost must be assured to approx. -25 ° C (in arctic climatic countries to approx. -35 ° C).
  • The coolant concentration must not be reduced by adding water even in warmer seasons and in warmer countries. The anti-freeze ratio must be at least 40%.
  • If for climatic reasons a higher frost protection is required, the amount of G 12 can be increased, but only up to 60% (frost protection to about -40 ° C), as otherwise frost protection is reduced again and cooling effectiveness is also reduced.
  • Refractometer T10007 is recommended for determining the current density of the anti-freeze.
  • If radiator, heat exchanger, cylinder head or cylinder head gasket are replaced, do not reuse old coolant.

Recommended mixture ratios:

Anti-freeze to Anti-freeze proportion G 12 * See note Water * See note2)
-25 ° C -35 ° C 40% 50% 3.7 l 4.6 l 5.5 l 4.6 l

* The quantity of coolant can vary in accordance with the equipment fitted to the vehicle.

* Only use clean drinking water.