Checking activation
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Volkswagen GTI, 2004 Volkswagen Jetta, 2004 Volkswagen GTI, 2003 Volkswagen Jetta, and 2003 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.
- Switch ignition off and on again.
- Connect diode test lamp VAG 1527 B to disconnected connector for After-Run Coolant pump V51 with adapter cables from VAG 1594 A. LED must light up.
NOTE:
- This check must be performed within 10 minutes after switching ignition off.
If the LED does not light up:
- Locate and eliminate open circuit referring to wiring diagram: → Electrical Wiring Diagrams, Troubleshooting and Component Locations