Valve stem seals, replacing: Removing

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2005 Volkswagen GTI, 2004 Volkswagen Jetta, 2004 Volkswagen GTI, 2003 Volkswagen Jetta, and 2003 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.

Remove camshafts → Camshafts, removing and installing .
Remove roller rocker finger together with support elements and place on a clean surface.

NOTE:

Ensure the roller rocker fingers and the support elements are not interchanged.

Remove spark plugs with Spark plug wrench 3122 B.
Set piston of corresponding cylinder to "bottom dead center".

Fig 1: Identifying Adjustable Rod 2036, Adapter T40012 And Valve Lever VW 541/1 A

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Fit assembly appliance 2036 with adapter plates 2036/1 and adjust mountings.
Screw adapter T40012 into threaded hole for spark plug and apply a continuous pressure of at leas 6 bar
Remove valve springs with assembly lever VW 541/1A and thrust piece VW 541/6.

NOTE:

Tight cotters can be loosened by tapping lightly on the lever with a hammer.

Pull off valve stem seals with Puller 3364.