Work sequence
WARNING: This page is about a different car, the 2006 Volkswagen Golf, 2005 Volkswagen Jetta, 2005 Volkswagen Golf, 2004 Volkswagen Jetta, and 2004 Volkswagen Golf. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect glow plug connector.
- Connect diode test lamp wire using clips from auxiliary cable set to battery positive (+).
- Place diode test lamp test probe on each glow plug one after another. Diode lights up: glow plug OK; diode does not light up: Replace glow plug.
- Remove and install glow plugs with jointed wrench 3220. Tightening torque: 15 Nm