Diesel direct injection system, component locations overview
Components A to D are not shown on the illustration.
A - Brake pedal switch -F47-
- In footwell on brake pedal
B - Brake light switch -F-
- In footwell on brake pedal
C - Throttle Position (TP) sensor -G79-
- In footwell on accelerator
D - Clutch vacuum vent valve switch -F36-
- In footwell on clutch pedal
1 - Variable intake manifold flap
- With Motor for intake flap -V157-
2 - EGR vacuum regulator solenoid valve -N18-
3 - Intake Manifold Runner Control (IMRC) valve -N316-
4 - Exhaust gas recirculation (EGR) cooler switch-over valve -N345-
5 - Wastegate bypass regulator valve -N75-
6 - Diesel Direct Fuel Injection (DFI) Engine Control Module (ECM) -J248-
- With Barometric pressure (BARO) sensor -F96-
- Replacing, refer to Engine control module
7 - Positive Crankcase Ventilation (PCV) heating element -N79-
8 - Engine Coolant Temperature (ECT) sensor -G62-
- For engine control module
- With Engine Coolant Temperature (ECT) sensor -G2-.
- If necessary, release pressure in cooling system before removing
9 - Mass Air Flow (MAF) sensor -G70-
10 - Connector
- For unit injector ( -N240-...-N243- )
11 - Engine speed (RPM) sensor -G28-
12 - Fuel temperature sensor -G81-
13 - Connector
- For Camshaft Position (CMP) sensor -G40-
14 - Connector
- For Engine speed (RPM) sensor -G28-
15 - Camshaft Position (CMP) sensor -G40-
16 - Manifold Absolute Pressure (MAP) sensor -G71- with Intake Air Temperature (IAT) sensor -G72-