Thermostat, removing and installing: Installing
WARNING: This page is about a different car, the 2006 Volkswagen Golf, 2005 Volkswagen Jetta, 2005 Volkswagen Golf, 2004 Volkswagen Jetta, and 2004 Volkswagen Golf. However, it is still accessible from the selected car via links, so may be relevant.
Installation is performed in the reverse order. When installing, note the following:
- Moisten new O-ring - 3 - with coolant.
- Insert thermostat - 4 - into connecting union - 2 - and turn 14 turn (90 ° ) to right.
NOTE:
- The brace on the thermostat must be almost vertical.
- Fit connecting union - 2 - with thermostat - 4 - into engine block.
- Tighten securing bolts - 1 -. Tightening torque: 15 Nm
- Fill with coolant. Refer to Coolant, draining and filling .