Coolant pump, removing and installing: Installing
WARNING: This page is about a different car, the 2006 Volkswagen Golf, 2005 Volkswagen Jetta, 2005 Volkswagen Golf, 2004 Volkswagen Jetta, and 2004 Volkswagen Golf. However, it is still accessible from the selected car via links, so may be relevant.
Installation is performed in reverse order. Note the following:
- Moisten new O-ring - 3 - with coolant.
- Insert coolant pump - 2 - into cylinder block and tighten securing bolts - 1 -. Tightening torque: 15 Nm
NOTE:
- The coolant pump sealing plug faces downward.
- Install toothed belt and tension. Refer to Toothed belts, removing, installing and tensioning .
- Fill with coolant. Refer to Coolant, draining and filling .