Oil pan, removing and installing: Removing

WARNING: This page is about a different car, the 2006 Volkswagen Golf, 2005 Volkswagen Jetta, 2005 Volkswagen Golf, 2004 Volkswagen Jetta, and 2004 Volkswagen Golf. However, it is still accessible from the selected car via links, so may be relevant.

Remove center, left and right sound insulation trays: → Body Exterior - Repair Group 50
Drain engine oil.

NOTE:

Observe disposal regulations!

Remove securing bolts for oil pan.
Loosen oil pan with light blows of a rubber-headed hammer, if necessary.
Remove oil pan.
Remove sealant residue on cylinder block with a flat scraper.

Fig 1: Removing Sealant Residue From Oil Pan With A Rotating Brush

GW00000130

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove sealant residue on oil pan with a rotating brush, e.g. a drill motor with a plastic brush (wear eye protection).
Clean sealing surfaces. Surfaces must be free of oil and grease.