Part I
WARNING: This page is about a different car, the 2006 Volkswagen Golf, 2005 Volkswagen Jetta, 2005 Volkswagen Golf, 2004 Volkswagen Jetta, and 2004 Volkswagen Golf. However, it is still accessible from the selected car via links, so may be relevant.
Part II - Disassembling oil filter bracket
Part III - Removing and installing oil supply lines.
1 - 15 Nm
2 - Sealing flange
- With seal
- Must be located on dowel sleeves
- Removing and installing. Refer to Sealing flange - belt pulley end, removing and installing
- Insert with silicone sealant D 176 404 A2 . Refer to Sealing flange - belt pulley end, removing and installing
- Do not additionally oil or grease oil seal sealing lip
- Before installing, remove oil residue from crankshaft journal using a clean cloth
- Replacing crankshaft oil seal - belt pulley end. Refer to Crankshaft oil seal - belt pulley end, replacing
3 - Chain tensioner with tensioning rail, 15 Nm
- When installing, pretension spring
4 - Dipstick
- Oil level must not be above Max. mark!
- Marking
5 - Guide
- Pull off to extract oil
6 - Guide tube
7 - Oil spray jet
- For piston cooling
8 - 25 Nm
- Insert without sealant
9 - Dowel sleeves
10 - 15 Nm
11 - Suction line
- Clean strainer if soiled
12 - O-ring
- Replace
13 - Baffle plate
14 - 15 Nm
15 - 15 Nm
16 - Oil pan
- Clean sealing surface before installing
- Install with silicone sealant D 176 404 A2 . Refer to Oil pan, removing and installing
17 - Seal
- Replace
18 - Oil drain plug, 30 Nm
- Replace plug with permanently attached seal
19 - Oil pump
- With pressure relief valve of 12 bar
- Before installing, check that both dowel sleeves are installed for centralizing oil pump/cylinder block
- Replace if running surfaces and gears are scored
20 - Chain sprocket for oil pump
21 - 25 Nm
22 - Chain