LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2001 >> Jetta GL, 2.0 B >> Repair and Diagnosis >> External Pages >> Different car >> Section 75 (1.9L - TDI Engine Mechanical, Fuel Injection Glow Plug, Engine Code(S): BEW (A4 Platform)) >> 13 - Engine - Crankshaft, Cylinder Block >> Engine, disassembling and assembling >> Poly V-belt, removing and installing >> Installing

Poly V-belt, removing and installing: Installing

WARNING: This page is about a different car, the 2006 Volkswagen Golf, 2005 Volkswagen Jetta, 2005 Volkswagen Golf, 2004 Volkswagen Jetta, and 2004 Volkswagen Golf. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • Before installing the poly V-belt, ensure that all ancillaries (Generator, air conditioning compressor, power steering pump) are secured tightly.
  • When installing the poly V-belt, check the direction of belt rotation and for proper seating of the belt in the pulleys.
  • For vehicles without air conditioning, put the poly V-belt over the Generator pulley last.
  • For vehicles with air conditioning, put the poly V-belt over the air conditioning compressor pulley last.

After completing repairs always:

Fig 1: Ribbed Belt Routing - With No Air Conditioning Compressor
GW00000026Courtesy of VOLKSWAGEN UNITED STATES, INC.

Belt drive for vehicles without air conditioning

Fig 2: Ribbed Belt Routing - With Air Conditioning Compressor
GW00000027Courtesy of VOLKSWAGEN UNITED STATES, INC.

Belt drive for vehicles with air conditioning

scientia non olet · About LEMON Manuals