Freeze frame data, mode 2

WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 1999 Volkswagen Jetta, 1999 Volkswagen Golf, 1999 Volkswagen Cabrio, 1998 Volkswagen Jetta, and 1998 Volkswagen Golf. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: If a malfunction is detected by the Engine Control Module (ECM) and is then stored, simultaneously, the operating conditions existing at the time the malfunction was stored will also be stored, and can be interrogated via mode 2.
Breakdown of the (PID) identification parameters. See DIAGNOSTIC DATA .

Press -2- button to select mode 2 freeze frame data.

Display will appear as shown

Fig 1: VAG 1551/1552 Scan Tool Display For Freeze Frame Data Mode 2

Press --> button.

Module 10* or 1A* will be activated (alternately):

Module 10 = Engine Control Module (ECM) -J220-
Module 1A = Transmission Control Module (TCM) -J217-

Press --> button, and the operating conditions will be printed out as a block, assuming there is a DTC stored in DTC memory.
Mode 2 can be exited by pressing the -C- button.