Displaying DTC blink codes
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 1995 Volkswagen Jetta III, 1995 Volkswagen Golf III, 1995 Volkswagen Cabrio, 1994 Volkswagen Jetta III, and 1994 Volkswagen Golf III. However, it is still accessible from the selected car via links, so may be relevant.
- Switch ignition ON.
- Connect OBD1 adapter to Data Link Connector (DLC) for 2.5 seconds, then disconnect.
- First blink code will be displayed
NOTE:
The code 4-4-4-4 indicates no malfunctions stored.
- Connect OBD1 adapter again for 2.5 seconds, then disconnect.
- Next blink code will be displayed
- Repeat procedure, connecting and disconnecting adapter and reading additional blink codes, until no more codes are displayed (0-0-0-0).
- Switch ignition OFF.