Safety precautions
WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2002 Volkswagen Cabrio, 2001 Volkswagen Cabrio, 2000 Volkswagen Cabrio, 1999 Volkswagen Jetta, and 1999 Volkswagen Golf. However, it is still accessible from the selected car via links, so may be relevant.
To prevent injuries to persons and/or damage to the fuel injection and ignition system, the following must be noted:
- Do not touch or disconnect ignition wiring when the engine is running or being turned at starter speed.
- The ignition must be switched off before connecting or disconnecting injection or ignition system wiring or tester cables.
- If the engine is to be turned at starter speed, without starting:
- Disconnect 3-pin harness connector from power output stage for ignition coil.
- Remove fuse 32
NOTE:
Removing fuse 32 interrupts the voltage supply to the injectors.
Observe following if test and measuring instruments are required during a test drive:
- Test and measuring instruments must be secured to rear seat and operated by a 2nd person from this location.
If test and measuring instruments are operated from front passenger's seat and the vehicle is involved in an accident, there is a possibility that the person sitting in this seat may receive serious injuries when the airbag is triggered.