LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2001 >> Jetta GL, 2.0 B >> Repair and Diagnosis >> External Pages >> Different car >> Section 53 (2.0L On Board Diagnostic (OBD) - Aba (A3 Platform)) >> Output Diagnostic Test Mode (DTM) (scan tool function 03) >> Test conditions

Test conditions

WARNING: This page is about a different car, the 2002 Volkswagen Cabrio, 2001 Volkswagen Cabrio, and 2000 Volkswagen Cabrio. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • The Output Diagnostic Test Mode (DTM) can only be carried out if the engine is stationary and ignition switched on.
  • The Output Diagnostic Test Mode (DTM) will be aborted if the engine is started or a rotational impulse is recognized.
  • During the Output Diagnostic Test Mode (DTM) the individual final controls will be activated until advancing to the next final control by pressing the --> button.
  • The final controls are checked acoustically or by touching.
  • If it is necessary to repeat the Output Diagnostic Test Mode (DTM), without first running the engine briefly, switch the ignition off for approx. 2 seconds.
  • The electric fuel pump will run during the complete Output Diagnostic Test Mode (DTM).
  • The Output Diagnostic Test Mode (DTM) will be aborted after 10 minutes.
scientia non olet · About LEMON Manuals