Functions which can be selected when using the scan tools VAG 1551/1552 or VAS 5051

WARNING: This page is about a different car, the 2002 Volkswagen Cabrio, 2001 Volkswagen Cabrio, and 2000 Volkswagen Cabrio. However, it is still accessible from the selected car via links, so may be relevant.

The prerequisites to select the desired functions can be found in the following table.

FUNCTION AND PREREQUISITE USING SCAN TOOLS VAG 1551/1552 OR VAS 5051

Function

Prerequisite

Functions on VAG 1551/1552 or on VAS 5051

Engine stationary, ignition switched on

Engine running at idling speed

Vehicle being driven

Check Control Module Versions

yes

Check DTC Memory

yes ⁽¹⁾

yes

Output Diagnostic Test Mode

yes

Basic Setting ⁽²⁾

yes

Erase DTC Memory

yes

End Output

yes

Code Control Module

yes

Read Measuring Value Block

yes

Adaptation

yes

Display readiness code

yes

⁽¹⁾	Only carry out with ignition switched on, when engine does not start (operate starter for at least 6 seconds first).

⁽²⁾	Must be carried out after the following: Replacing engine control module, throttle valve control module, engine or disconnecting battery.