Fuel injectors, removing and installing: Installing
WARNING: This page is about a different car, the 1999 Volkswagen Jetta, 1998 Volkswagen Jetta, and 1997 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Always replace the heat shield located between the cylinder head and each of the fuel injectors.
- Insert fuel injector.
- Make sure that mounting is seated correctly in cylinder head.
- Install retainer.
Tightening torques:
- Injector lines: 25 Nm (18 ft lb)
- Retainer nut: 20 Nm (15 ft lb)
- Check and erase DTC memory, see ERASE DTC MEMORY (SCAN TOOL FUNCTION 05) .
- Re-create readiness code, see READINESS CODE, SETTING (UP TO M.Y. 1997) .