Transmission, removing and installing: Installing
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 1995 Volkswagen Jetta III, 1995 Volkswagen Golf III, 1995 Volkswagen Cabrio, 1994 Volkswagen Jetta III, and 1994 Volkswagen Golf III. However, it is still accessible from the selected car via links, so may be relevant.
The transmission is installed in the reverse order of removal.
When installing the torque converter, make sure that both drive pins engage in the ATF pump inner wheel recesses.
- Before installing, make sure that dowel sleeves for aligning the engine and transmission are correctly located.
- Replace selector cable anchorage locking washer.
- Check selector lever cable adjustment, and adjust if necessary. See Selector lever cable, checking and adjusting .