Basic setting, initiating (function 04)

• Engine replacement
• Engine control module (ECM) replacement
• Replacing/altering throttle valve (setting idling speed)
• Throttle Position (TP) Sensor -G69-replacement
• TP Sensor -G69- setting alteration, e.g. when adjusting Closed Throttle Position (CTP) switch (engine)
• Transmission Control Module (TCM) -J217-replacement
  • Connect VAG 1551 Scan Tool and enter address word "02 Transmission electronics." Advance until "Select function XX" appears in the display. See VAG 1551 Scan Tool (ST), connecting and selecting functions .

Indicated on display:

Fig 1: Basic Setting, Initiating (1 Of 5)

Courtesy of VOLKSWAGEN OF AMERICA, INC.

• Press buttons -0- and -4- to select function 04, Initiating basic setting.

Indicated on display:

Fig 2: Basic Setting, Initiating (2 Of 5)

Courtesy of VOLKSWAGEN OF AMERICA, INC.

• Press -Q- button to confirm entry.

Indicated on display:

Fig 3: Basic Setting, Initiating (3 Of 5)

Courtesy of VOLKSWAGEN OF AMERICA, INC.

• Press buttons -0-, -0- and -0-.
• Press -Q- button to confirm entry.

Indicated on display:

Fig 4: Basic Setting, Initiating (4 Of 5)

Courtesy of VOLKSWAGEN OF AMERICA, INC.

The system is now in basic setting.

• Depress accelerator pedal as far as kickdown and hold this position for 3 seconds.
• Press button.

Indicated on display:

Fig 5: Basic Setting, Initiating (5 Of 5)

Courtesy of VOLKSWAGEN OF AMERICA, INC.