Conductor strip, removing and installing

WARNING: This page does not describe the selected car, but rather 25 other vehicles, including the 2002 Volkswagen Cabrio, 2001 Volkswagen Cabrio, 2000 Volkswagen Cabrio, 1999 Volkswagen Jetta, and 1999 Volkswagen Golf. However, it is still accessible from the selected car via links, so may be relevant.

Separate connector at transmission and remove retaining clamp.
Drain ATF and remove oil pan
Remove cable guide
Pry conductor strip off solenoid valve in direction of arrow using special tool 3373.

Fig 1: Removing And Installing Conductor Strip
Courtesy of VOLKSWAGEN OF AMERICA, INC.

NOTE: If locating points are damaged, valve body must be replaced.

Install in reverse order of removal.