Valve guides, replacing: Installing

WARNING: This page is about a different car, the 1999 Volkswagen Jetta, 1998 Volkswagen Jetta, 1997 Volkswagen Jetta, 1996 Volkswagen Passat, and 1996 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

Coat new guides with oil and press in using 10 - 206 drift from camshaft side (cylinder head cold) until shoulder of new guide just contacts head.
CAUTION: When the shoulder on the new guide makes contact, the pressing force must not exceed 1.0 ton or the guide shoulder could break off.
Ream guides out using 10-215 hand reamer using plenty of cutting fluid.
Reface valve seats, see Valve seats, refacing .