Engine code AAZ
WARNING: This page is about a different car, the 1999 Volkswagen Jetta, 1998 Volkswagen Jetta, 1997 Volkswagen Jetta, 1996 Volkswagen Passat, and 1996 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect accelerator pedal cable at injection pump lever, remove mounting clip on support bracket and release cable.
- Disconnect cold start accelerator cable.
- First tighten right rear engine mount, then left rear engine mount.
When installing the engine mounts, the recesses on the right rear engine mount bracket and front engine mount must engage in the guide pins of the bonded rubber mounts (arrows).
- Loosen front engine mount on carrier, align stress-free by rocking engine/transmission assembly and then re - tighten.CAUTION:
- Do not interchange the hollow banjo bolts for the fuel supply and return line fittings.
- The return line has a smaller diameter bore and has an "OUT" marking on the bolt head.
- Adjust Cold Start Accelerator (CSA) cable, see COLD START ACCELERATOR (CSA) CABLE, ADJUSTING .
- Adjust accelerator cable, see ACCELERATOR PEDAL LINKAGE, SERVICING .