Adhesive residue removal

WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 2002 Volkswagen Cabrio, 2001 Volkswagen Cabrio, 2000 Volkswagen Cabrio, 1999 Volkswagen Jetta, and 1999 Volkswagen Golf. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Always read and follow manufacturer Cautions and Warnings regarding use of product.

If RAPGARD® adhesive residue remains on paint finish, remove with a non-abrasive polishing product such as, (3M Part No. 5995) light colors or (3M Part No. 5996) dark colors.

Thick lines of adhesive residue can be removed with general purpose adhesive cleaner (3M Part No. 08987-aerosol, or Part No, 08984 -qt. can) or equivalent.

NOTE: Paint discoloration (looks like shaded or dark magic marker lines) can be removed with a heat gun using the following procedure:

Hold heat gun approximately 3 in. away from affected paint surfaces and apply heat using slow oscillating motions until discoloration is gone.
If discoloration remains, wipe the heated area with Isopropyl alcohol and repeat procedure to increase surface drying.

IMPORTANT: After inspecting and removing RAPGARD®, washing vehicle, inspecting and repairing any defects in paint surfaces, moldings and glass:

Protect the vehicle paint surface by applying 3M Perfect-It ™ Paste Wax (3M Part No. 39526) or equivalent.