Hood alarm switch -F120-, removing and installing: Removing
WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 2002 Volkswagen Cabrio, 2001 Volkswagen Cabrio, 2000 Volkswagen Cabrio, 1999 Volkswagen Jetta, and 1999 Volkswagen Golf. However, it is still accessible from the selected car via links, so may be relevant.
- Remove 2-pin connector from contact switch.
- Remove contact switch from mounting bracket.
Install in reverse order of removal.
NOTE:
The switch will only operate properly if it has been correctly installed. After repairs, check the installation if necessary.