Stall speed, checking: Notes
WARNING: This page does not describe the selected car, but rather 25 other vehicles, including the 2002 Volkswagen Cabrio, 2001 Volkswagen Cabrio, 2000 Volkswagen Cabrio, 1999 Volkswagen Jetta, and 1999 Volkswagen Golf. However, it is still accessible from the selected car via links, so may be relevant.
- Connect tachometer, e.g. VAG 200 VW1367 or equivalent to engine or with VAG 1551 Scan Tool read engine rpm in measuring value block.
- Lock wheels with parking brake and foot brake.
- Start engine and place selector lever in D position
- Briefly apply Wide Open Throttle (max. 5 seconds). If necessary repeat after 20 seconds. The stall speed listed in the chart must be attained.
- If end speed is not attained, check the items listed in STALL SPEED, CHECKING table.
STALL SPEED, CHECKING
| Stall Speed | Possible Fault |
|---|---|
| Stall speed too high: | Forward clutch slips, One-way clutch slips |
| Stall speed up to 200 rpm too low: | Check engine adjustment |
| Stall speed over 200 rpm too low: | Torque converter faulty |
If in doubt, always check the engine adjustment and correct if necessary.
The correct torque converter must always be installed with the correct transmission.