Engine Control Module or Fuel Cut-off Valve Control Module, procedure after replacing: Procedure
WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 2002 Volkswagen Cabrio, 2001 Volkswagen Cabrio, 2000 Volkswagen Cabrio, 1999 Volkswagen Jetta, and 1999 Volkswagen Golf. However, it is still accessible from the selected car via links, so may be relevant.
After control module identification has been displayed:
- Press --> button.
Indicated on display:
Fig 1: Identifying VAG 1551 Scan Tool Display (Cabrio Up To May 1999 - Engine Control Module Or Fuel Cut-off Valve Control Module) (Rapid Data Transfer)
- Press buttons -1- and -0-. (10 selects the "Adaptation" function.)
Indicated on display:
Fig 2: Identifying VAG 1551 Scan Tool Display (Cabrio Up To May 1999 - Engine Control Module Or Fuel Cut-off Valve Control Module) (10 Adaption)
- Confirm entry with -Q- button.
Indicated on display:
Fig 3: Identifying VAG 1551 Scan Tool Display (Cabrio Up To May 1999 - Engine Control Module Or Fuel Cut-off Valve Control Module) (Enter Channel Number XX)
- Press button -0- twice. (00 selects "Channel 0".)
- Confirm entry with -Q- button.
Indicated on display:
Fig 4: Identifying VAG 1551 Scan Tool Display (Cabrio Up To May 1999 - Engine Control Module Or Fuel Cut-off Valve Control Module) (Erase Learned Value)
- Confirm entry with -Q- button.
Indicated on display:
Fig 5: Identifying VAG 1551 Scan Tool Display (Cabrio Up To May 1999 - Engine Control Module Or Fuel Cut-off Valve Control Module) (Learned Values Are Erased)
- Press --> button.
Indicated on display:
Fig 6: Identifying VAG 1551 Scan Tool Display (Cabrio Up To May 1999 - Engine Control Module Or Fuel Cut-off Valve Control Module) (Select Function XX)
NOTE:
The engine control module or the fuel cut-off valve control module identification will be stored in the Immobilizer Control Module and the engine can be started.