LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2001 >> Jetta GL, 2.0 B >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (5 SPD. Manual Transmission 02A (A3 Platform)) >> Manual Transmission - Gears, Shafts >> Output shaft, disassembling and assembling >> Pulling off operating sleeve with synchro-hub using bearing support

Pulling off operating sleeve with synchro-hub using bearing support

WARNING: This page is about a different car, the 1999 Volkswagen GTI, 1998 Volkswagen GTI, 1997 Volkswagen GTI, 1996 Volkswagen GTI, and 1995 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.
  1. - Two arm puller, e.g. US 1078 or Kukko 20/10, and hooks with 250 mm reach, e.g. US 1079
  2. - 17 mm hex -head bolt (M10 x 20)
    NOTE: Remove circlip before pulling off individual components.
    3. Fig 1: Pulling Off Operating Sleeve With Synchro-Hub Using Bearing Support
    G03362197Courtesy of VOLKSWAGEN OF AMERICA, INC.
scientia non olet · About LEMON Manuals