Door, removing and installing

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 1999 Volkswagen Jetta, 1999 Volkswagen Golf, 1999 Volkswagen GTI, 1998 Volkswagen Jetta, and 1998 Volkswagen Golf. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect harness connector at A-pillar. On vehicles with central locking, disconnect bi-pressure line in harness connector.
Loosen nut -4- and remove bolt -3-.
Loosen Torx(R) bolts -1- and remove door. Use Torx(R) bit T45.
Max. length: 35 mm (1-3/8 in.)
Remove screw -2- from upper and lower hinges.
Tightening torque: 23 N.m (17 ft lb)
Lift door upward and out of hinge brackets.

Fig 1: Removing Front Door Attachment Bolts, Screw & Nuts (Front Door)