Adjustment summary
WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2002 Volkswagen Cabrio, 2001 Volkswagen Cabrio, 2000 Volkswagen Cabrio, 1999 Volkswagen Jetta, and 1999 Volkswagen Golf. However, it is still accessible from the selected car via links, so may be relevant.
When servicing the transmission, adjustment of the output shaft (pinion), final drive gear or gear set is necessary only if components that have a direct effect on the adjustment of the final drive unit are replaced. Refer to the COMPONENT ADJUSTED REFERENCE table to avoid unnecessary adjustment!
COMPONENT ADJUSTED REFERENCE
| Component to be adjusted | ||
|---|---|---|
| Output shaft See OUTPUT SHAFT, ADJUSTING |
Differential (shims S1 and S2) See DIFFERENTIAL, ADJUSTING |
|
| Part being replaced: Transmission housing | X | |
| Clutch housing | X | X |
| Tapered roller bearing for differential | X | |
| Differential gear set | X | |
| Differential housing | X | |
| Output shaft tapered roller bearing | X | |