Flange shaft oil seals, replacing: Installing
WARNING: This page is about a different variant/trim than selected.
- Drive seal into sleeve onto stop. Do not tilt seal.
- Fill space between sealing lip and dust lip with grease G 052 128 A1.
- Insert flange shaft.
- Install cone head bolt into flange shaft threaded piece.
- Install left side axle shaft or attach right side shaft to flange shaft.
Refer to 40 FRONT SUSPENSION
- Install axle shaft protective cover if necessary.
- Top up transmission oil. Refer to Gear oil, checking .
Tightening torques
| Flange shaft to transmission (cone head bolt) | 25 Nm | |
| Axle shaft protective cover to engine | 35 Nm | |