Assembling locking collar and locking pieces with 1st and 2nd gear synchro-hub
WARNING: This page is about a different variant/trim than selected.
1 - Spring
2 - Locking collar
3 - Synchro-hub
4 - Locking piece
With introduction of the modified 1st gear synchronization the shoulder has the same width on both sides of synchro-hub.
The shoulder has a chamfer on one side (arrow -B-).
After assembly the shoulder of the synchro-hub and the outer splines of the locking collar (arrow -A-) face same direction.
Recesses for locking pieces on synchro-hub and locking collar (arrow -C-) must align.