Cover for transmission housing and 5th gear, removing and installing
WARNING: This page is about a different variant/trim than selected.
1 - Hex bolt, 10 Nm
- For transmission housing cover
2 - Transmission housing cover
NOTE:
If the transmission cover is fitted with the transmission installed, check oil level as follows:
- Fill with oil up to lower edge of filler hole and fit filler plug.
- Start engine, engage gear and allow transmission to turn for approx. 2 minutes.
- Switch off engine and top up transmission oil to lower edge of filler hole again.
3 - Gasket
4 - Torx socket head bolt M10, 80 Nm
- Fitted piece on bolt head holds saucer spring washer in position
6 - Dished spring
- Installing. Refer to Assembly sequence
7 - Socket head bolt, 25 Nm
- For pivot pin to transmission housing
8 - Pivot pin
9 - 5th gear selector fork
- Disassembling and assembling. Refer to Selector forks, disassembling and assembling
- Adjusting. Refer to Assembly sequence
10 - 5th gear locking collar
- Installation position. Refer to Assembly sequence
- Adjusting. Refer to Assembly sequence
11 - Synchro-hub with 5th gear and synchronizing ring
- Disassembling and assembling. Refer to 5th gear synchronizer
12 - Needle roller bearing
13 - 5th gear
- Installation position. Refer to Installation position 5th gear