Gear lever and gear lever housing, servicing: Notes
WARNING: This page is about a different variant/trim than selected.
NOTE:
Lubricate all mountings and sliding surfaces with Polyurea grease Part No. G 052 142 A2.
1 - Circlip
- Removing and installing. See Removing and installing circlip
2 - Bushing
3 - Spring
4 - Bushing
5 - Torx screw, 5 Nm
6 - Cover plate
7 - Damper
8 - Bearing shell
9 - Gear shift guide
10 - Damping washer
11 - Gasket
- Between selector housing and floor
- Self-adhesive
- Bond to gear lever housing
12 - Transmission selector lever
13 - Damper
14 - Selector housing
15 - Bushing
16 - Bolt, 25 Nm
17 - Fulcrum pin
18 - Guide bushing
19 - Spring
- Installing. See Installing spring
20 - Gate selector bracket
21 - Torx screw, 5 Nm
22 - Base plate
- Open tabs to remove
- Replace
23 - Lock washer
24 - Gate selector cable
- On gate selector bracket
- Installation position. Refer to Installation position of gear selector mechanism
25 - Gear selector cable
- Press onto gear shift guide
- Installation position. Refer to Installation position of gear selector mechanism
26 - Hex nut, 25 Nm
27 - Bushing
- Only fits in one position
28 - Lock washer