Over-center spring, removing and installing: Installing

• Pull clutch pedal into passenger compartment.

Fig 1: Installing Over-Center Spring Together With Assembly Device T10111 Into Support

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Insert over-center spring with assembly clamp T10111 upward (in direction of arrow -A-) into bearing bracket and then turn in direction of arrow -B-.

Fig 2: Identifying Rear Support & Clutch Pedal Bearing Tab

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Insert over-center spring into rear mounting first -A-.
• Operate clutch pedal until over-center spring seats on mounting tab (arrow -B-) of clutch pedal.
• Take out assembly clamp while bringing clutch pedal to rest position.
• Install driver's side lower cover.

Refer to 70 - INTERIOR TRIM