Clutch pedal, removing and installing: Installing
WARNING: This page is about a different variant/trim than selected.
Installation is performed in the reverse sequence, when doing this note the following:
- Install over-center spring. Refer to Over-center spring, removing and installing .
- Fit retainer -A- to master cylinder operating rod -B-.
- Press clutch pedal in direction of arrow to engage. Ensure correct location.
- Fill brake fluid reservoir up to "max" marking with brake fluid.
Refer to 47 BRAKES - HYDRAULIC COMPONENTS
Bleeding clutch system when fluid level is below "min" marking. Refer to Clutch system, bleeding .