Continuation for 115...135 Ω

WARNING: This page is about a different variant/trim than selected.

Release Engine Control Module (ECM) connector and remove.
Check CAN-Bus wiring with terminal resistor in ABS Engine Control Module (ECM) J248.
Measure resistance between test box sockets 3 + 25:

Specification: 115 to 135 Ω

If resistance is outside specification:

If wiring to ABS Control Module J104 is OK:

Replace ABS Control Module J104. → 45 ANTI-LOCK BRAKE SYSTEM
Check DTC memory, if necessary, repair any malfunctions and erase DTC memory → Diagnostic Trouble Code (DTC) memory, checking and erasing .
Display readiness code → Readiness code, displaying . If DTC memory has been erased, reset readiness code → Readiness code, setting .

If resistance is within specification:

Fig 1: Releasing ABS Control Module Connector

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Release ABS Control Module connector and remove.
Check CAN-Bus wiring with terminal resistor in Engine Control Module (ECM) J248 :
Measure resistance between test box sockets 3 + 25:

Specification: 115 to 135 Ω

If resistance is not within specification:

If no wiring damage is found: