Evaporative Emission (EVAP) canister system, checking for proper seal
WARNING: This page is about a different variant/trim than selected.
Special tools, testers and auxiliary items required
- Smoke tester.
- EVAP and Fuel Supply System Vacuum hose and line routing diagram.
NOTE:
- Secure all hose connections using hose clamps appropriate for the model type Parts catalog.
- Replace seals and gaskets when performing repair work.
Leak checking
- Using a Smoke tester , check the Evaporative Emission (EVAP) canister system for leaks.
NOTE:
- Always follow the manufacturers directions for the proper installation and operation of the Smoke tester being used.
If a leak is detected:
- Check the fuel filler cap seal for damage and for proper installation. Replace if necessary.
- Check the seals under the locking flanges and the union nuts are properly tightened on the fuel tank.
- Check all hose connections of the fuel supply system and replace or repair any leaking lines.
- Check all hose connections of the EVAP system and replace or repair any leaking lines.
- Repair or replace any damaged component.
If no leaks are found in the EVAP and Fuel Supply System:
- Erase the DTC memory if a DTC was set. Refer to → Diagnostic Mode 04: Reset/delete diagnostic data .
- Perform a road test to verify repair.
If a DTC was set and does not return:
Repair complete, Generate readiness code. Refer to → Readiness Code .
- End diagnosis.
If the DTC does return and no leaks are found in the EVAP and Fuel Supply System:
- Check the DTC memory for any DTC codes pertaining to the EVAP and Fuel Supply Systems. If a DTC is stored, perform the diagnostic test procedure for the suspected component. Refer to → Mode 03: Interrogating fault memory .
End diagnosis.