Evaluating display group 2, display zone 3 - Injection period

WARNING: This page is about a different variant/trim than selected.

Appears on display	Possible cause	Corrective action
Less than 2.0 ms	Large amount of fuel from the Evaporative Emission (EVAP) system	Check EVAP canister purge regulator valve → Output Diagnostic Test Mode (function 03), performing , Output Diagnostic Test Mode
	Incorrect injectors with greater throughput installed	Check injection rate → Injectors, checking
More than 4.0 ms	Increased engine load due to electric consumers, air conditioner, gear selected or power steering on full lock	Eliminate increased load (air conditioner, power steering etc.)