Evaluation display group 2, display field 3 - injection timing

WARNING: This page is about a different variant/trim than selected.

Indicated on display	Possible cause	Corrective action
less than 2.0 ms	High fuel quantity from EVAP canister system	Check Evaporative Emission (EVAP) Canister Purge Regulator Valve. Refer to Output Diagnostic Test Mode (DTM), initiating , Output Diagnostic Test Mode (DTM)
	Incorrect fuel injector with too much throughput installed	Check ignition quantity. Refer to Injectors, checking
larger than 4.0 ms	Increased engine load due to electrical consumers , A/C system, driving mode engaged or power steering at end-position	Repair increased load (A/C system, power steering etc.)